In the previous post, I shared about installing PowerCLI.
After you do that, you should get a GUI tool. I’m using PowerQUI. The free edition is good enough for my needs.
Below is the installation process. Just follow the wizard.
In the screen below, don’t forget to choose the “vSphere Client Integration”. It is not shown on the screen below.
Also, choose VMware in the PowerPacks. It is basically a “plug-in” to PowerGUI. You need to install vSphere PowerCLI first.
Follow the wizard. At the end of the process, you will see this screen. You can launch either.
Below is the console. I’ve already connected to vCenter. Simply by clicking the “Virtual Machines”, I got the list of VM.
Hope that helps.
No comments:
Post a Comment